This driver can be installed using [DKMS]. This is a system which will automatically recompile and install a kernel module when a new kernel gets installed or updated. To make use of DKMS, install the `dkms` package, which on Debian (based) systems is done like this:
```
sudo apt-get install dkms
```
### Installation of Driver
In order to install the driver open a terminal in the directory with the source code and execute the following command:
```
sudo ./dkms-install.sh
```
### Removal of Driver
In order to remove the driver from your system open a terminal in the directory with the source code and execute the following command:
```
sudo ./dkms-remove.sh
```
### Make
For building & installing the driver with 'make' use
You may also uncheck the box "Automatically connect to this network when it is avaiable" in nm-connection-editor. This only works if you have a saved wifi connection.
2. Set interface down
```
sudo ip link set wlan0 down
```
3. Set monitor mode
```
sudo iw dev wlan0 set type monitor
```
4. Set interface up
```
sudo ip link set wlan0 up
```
For setting TX power
```
sudo iw wlan0 set txpower fixed 3000
```
### LED control
#### You can now control LED behaviour statically by Makefile, for example:
```sh
CONFIG_LED_ENABLE = n
```
value can be y or n
#### statically by module parameter in /etc/modprobe.d/8812au.conf or wherever, for example:
```sh
options 88XXau rtw_led_enable=0
```
value can be 0 or 1
#### or dynamically by writing to /proc/net/rtl8812au/$(your interface name)/led_enable, for example:
